Table of Contents
Advertisement
User Manual of DS-6600 Audio/Video Encoder
Note:
If the device is connected to a public network, you should use a NTP server that has a time synchronization
function, such as the server at the National Time Center (IP Address: 210.72.145.44). If the device is set up in a
more customized network, NTP software can be used to establish a NTP server used for time synchronization.
Configuring Time Synchronization by Manually
Enable the Manual Time Sync function and then click the
calendar. You can check the checkbox of Snyc with local time to synchronize the time with the local PC.
4.
Configure DST settings if needed.
(1) Check the checkbox before the Enable DST.
(2) Set the start tine and end time of DST period. The end time must be later than the start time. When the DST
period ends, the system will reverts to the standard local time.
(3) Set the DST bias to 30min, 60min, 90min or 120min.
5.
Click the Save button to save the settings.
7.3 Network Settings
7.3.1 Configuring Basic Settings
Network settings must be properly configured before you operate device over network.
Figure 7.4 Time Sync by NTP Server
Figure 7.5 Time Sync by Manually
Figure 7.6 Set DST
43
icon to set the system time from the pop-up
Advertisement
Table of Contents
