Responding To Evacuation Indicator; Tactical Public Safety(Tps) (Conventional; Only); Using Tps Normal Transmission - Motorola APX 6000XE User Manual

the Volume Control Knob if necessary.
Release the Volume Set button.
• At the desired Fireground zone and channel,
press the preprogrammed Monitor button and
listen for activity. Adjust the Volume Control
Knob if necessary.
• If your radio is working in Fireground Zone
Channel, proceed to next step.
4 Press and hold the PTT button to transmit. The
LED lights up solid red while transmitting. Talk into
the microphone clearly if needed.
5 Release the PTT button to receive.
You hear a Transmit End Tone.

Responding to Evacuation Indicator

When Incident Commander triggers Evacuation
signal from his command terminal, the RF Modem
updates everyone in the Fireground Communication
System with the order to evacuate the incident site.
Your radio sounds the Evacuation Tone at the profile
maximum alert tone volume level. The display shows
EVACUATE.
Perform one of the following actions:
• Move the Volume Control Knob to adjust the
volume of the Evacuation Tone from full
volume.
• Perform any action on the radio other than
volume adjustments to cancel the evacuation
indications and update the command terminal.
• If preprogrammed with Manual
Acknowledgement of Evacuation Command,
pressing the PTT button shall cancel the
indications and acknowledge the command
terminal.

Tactical Public Safety(TPS) (Conventional

Only)

TPS enabled the user of a group to identify a
transmission starts and ends clearly by displaying the
caller name or ID on the radio display.

Using TPS Normal Transmission

At TPS Zone Channel, perform one of the
following actions:
• Press PTT button to transmit. Talk clearly into
the microphone. Release PTT button to listen.
53
English