Voice Announcement - Motorola APX 6000XE User Manual

data transfer without interrupting communication. The
upgrade pauses to give priorities to voice call, and
continues after the voice call ended.
Once a configuration upgrade is downloaded to your
radio, you can install new changes immediately or
delay changes to be installed on the radio when it is
being powered up.
Note: This feature must be preprogrammed by a
qualified radio technician. Check with your dealer or
system administrator for more information.

Voice Announcement

This feature enables the radio to audibly indicate the
current feature mode, zone or channel the user has
just assigned. This audio indicator can be customized
per customer requirements. This is typically useful
when the user is in a difficult condition to read the
content shown on the display.
Each voice announcement is within a limit of three
seconds maximum. The sum duration of all different
voice announcements in a radio shall be no more
than 1000 seconds.
Note: This feature must be preprogrammed by a
74 qualified radio technician.
English
Check with your agent if Voice Announcement is
available for the feature you need.
The two options of priority for the Voice
Announcement available are:
High Enables the voice of the feature to announce
even when the radio is receiving calls.
Low Disables the voice of the feature from
announcing when the radio is receiving calls.
You hear a voice announcement when the features
below are preprogrammed in the radio.
• The radio powers up. The radio announces the
current zone and channel it is transmitting.
• Press the preprogrammed voice announcement
button (which specifically programmed to playback
the current zone and channel). The radio
announces the current zone and channel it is
transmitting.
Note: Pressing this preprogrammed playback
button will always enable the voice feature to
announce in High priority.
All the three programmable buttons at the side of
the radio support this feature.