Table of Contents
Advertisement
4 Press and hold the PTT button to transmit. The
LED lights up solid red while transmitting. Talk into
the microphone clearly if needed.
5 Release the PTT button to receive.
You hear a Transmit End Tone.
Responding to Evacuation Indicator
When Incident Commander triggers Evacuation signal
from his command terminal, the RF Modem updates
everyone in the Fireground Communication System
with the order to evacuate the incident site.
Your radio sounds the Evacuation Tone at the profile
maximum alert tone volume level. The display shows
EVACUATE.
Perform one of the following actions:
•
Move the Volume Control Knob to adjust the
volume of the Evacuation Tone from full
volume.
•
Perform any action on the radio other than
volume adjustments to cancel the evacuation
indications and update the command terminal.
•
If preprogrammed with Manual
Acknowledgement of Evacuation Command,
pressing the PTT button shall cancel the
indications and acknowledge the command
terminal.
Tactical Public Safety (TPS) (Conventional
Only)
TPS enables the user of a group to identify the start
and the end of a transmission by displaying the caller
name or ID on the radio display.
Using TPS Normal Transmission
At TPS Zone Channel, perform one of the
following actions:
•
Press PTT button to transmit. Talk clearly into
the microphone. Release PTT button to listen.
•
Receive and listen to call, the radio displays the
caller's name or ID.
Using TPS Emergency Transmission
The following are two important alert tones designed
for this feature.
During Emergency if the TPS radio
Emergency
Beacon
user pushes the Emergency button,
55
English
Advertisement
Table of Contents
