Table of Contents
Advertisement
Install the Dovetail Mounting Module
2.3.3.
Release the Dovetail Saddle Locking Knob #16 under the Camera Mounting Platform #3. Retreat the
tip of the Locking Knob #16 below the surface of the Platform. Slide the Dovetail Mounting Module #4
into the Camera Mounting Platform #3. Tighten the Locking Knob.
Attach the Camera
2.3.4.
Remove the Camera Quick Release Plate #18 from the Dovetail Mounting Module #4 by releasing the
Plate Locking Knob #17. Install the Quick Release Plate #18 onto the camera tripod mounting hole of
your camera and align the edges. Tighten the brass screw using a coin if needed, as shown in Figure 6.
Mount the camera onto the Dovetail Mounting Module #4 by inserting the Quick Release Plate #18 into
the dovetail saddle. If the center of the lens of the camera is aligned with the tripod mounting hole, just
align the zero mark on the Quick Release Plate to the one on the dovetail saddle (Figure 7).
Figure 5. Install dovetail mounting module
Figure 6 Mount a Quick Release Plate onto a camera
9
Advertisement
Table of Contents
