Table of Contents
Advertisement
2.3. iPano Mount Assembly
2.3.1. Charge the battery
The iPano AllView Pro Mount uses a lithium rechargeable battery to power the mount. Please using the
included wall plug charger (8.4V/2A) to full charge the battery after receiving the mount. The LED
indicator remains RED during the charging process and will turn to GREEN when charge is complete.
DO NOT charge the mount with a 12V AC adapter/battery pack or a car cigarette plug. ONLY
charge the mount using the included battery charger! Charge the mount battery before every
operation.
NEVER charge the battery when it is below 0°C (32°F)
A low battery waning (a flashing battery status indicator or beeps) will occur if the battery is low. You
may keep using the mount by plug in a wall plug charger or a 7.4V-8.4V DC power source through DC
port #12. NEVER use this way when it is below 0°C (of 32°F).
If you mount equipped a Direct DC Power Socket (DC 5.5mmX2.1mm) located at the bottom of the
mount (Figure 3), you can use a 7.4V portable power pack to keep operating the mount. Turn off the
mount before switch to portable power pack.
Attach the Mount
2.3.2.
Carefully thread the iPano mount onto your tripod and make sure it is securely tightened. The mount
base has a 3/8" threaded socket. If your tripod only has a 1/4" threaded post, a 1/4" to 3/8" tripod
adapter screw (included) is needed,
Figure 3. Direct Power Socket for 7.4V portable power pack
Figure 4. Install the mount onto a tripod
8
Advertisement
Table of Contents
