Table of Contents
Advertisement
4.3. Time-lapse Photography
This Time-lapse Photography allows you to create time-lapse images while the camera is moving. You
can pan, tilt or move diagonally the camera while taking the time-lapse images. You can set the delay
between each picture you are taking. To take a time-lapse panorama (panoramas over a period of time,)
please refer to Global Settings =>Interval Timer.
Press MENU => Time-laps Photography. First move the camera to the staring position using the
arrow key. Press OK to confirm. Then move the camera to the end position. Press OK. Now you can
choose either total picture numbers or angle intervals for the whole swing.
Here is an example to take a Time-lapse photography from upper left corner (320°,20°) to lower right
corner (40°,-20°)
Matrix Panorama
Circular Panorama
Time-lapse Photography
Custom Settings Bank
Global Settings
System
40.00° -20.00°
Move camera to other
Diagonal position
[OK]=Continue
Total Number
4.3.1.
Enter the time delays (interval timer) between each picture. Use the ◄ and ► buttons to switch
between day, hour, minutes, and seconds. Use the ▲ and ▼ buttons to change the delay values where
cursor is blinking. Move the cursor down to Total number line using ► button. Set the total pictures
you want the camera to take with ▲ and ▼ buttons. Press OK to confirm. The mount will calculate the
angle intervals between each shot, and display total shots, interval timer and interval degrees. Press
OK to start.
Select Total Number
Select Interval Degree
Interval Degree
4.3.2.
Enter the time delays between each picture. Use the ◄ and ► buttons to switch between day, hour,
minutes, and seconds. Use the ▲ and ▼ buttons to change the delay values where cursor is blinking.
Move the cursor to Interval Degree line and set the angle that camera will move between each picture
taken. Press OK to confirm. The mount will calculate the total picture numbers. Press OK to start.
Select Total Number
Select Interval Degree
0.00°
0.00°
Move camera to start
position
[OK]=Continue
Select Total Number
Select Interval Degree
Please input interval timer:
0 0 D 0 0 h 1 5 m 0 0 s
Total number: 0 0 0 1 0
[X]=Back [OK]=Continue
Please input interval timer:
0 0 D 0 0 h 1 5 m 0 0 s
Interval degree: 0 8 .1°
[X]=Back [OK]=Continue
20
320.00°
20.00°
Move camera to end
position
[OK]=Continue
10
00D00h15m00s
8.10
[X]=Back [OK]=Continue
10
00D00h15m00s
8.10
[X]=Back [OK]=Continue
Advertisement
Table of Contents
