Table of Contents
Advertisement
Band - Select the desired protocol. The default setting is 2.4GHz (B+G+N).
2.4GHz (B) - Select if all of your wireless clients are 802.11b.
2.4GHZ (G) - Select if all of your wireless clients are 802.11g.
2.4GHz (N) - Select if all of your wireless clients are 802.11n.
2.4GHz (B+G) - Select if you are using both 802.11b and 802.11g wireless clients.
2.4GHz (G+N) - Select if you are using both 802.11g and 802.11n wireless clients.
2.4GHz (B+G+N) – Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
Mode - Select the desired wireless mode. AIP-W512 offers AP, Client, WDS, and AP + WDS.
When 802.11g mode is selected, only 802.11g wireless stations can connect to the router.
When 802.11n mode is selected, only 802.11n wireless stations can connect to the AP. It is
strongly recommended that you set the Mode to 2.4GHz (B+G+N) and all of 802.11b,
802.11g, and 802.11n wireless stations can connect to the router.
Network Type - After network mode is selected to "Client" set network type as
infrastructure or Ad-Hoc.
SSID - Enter a value of up to 32 characters. The same name of SSID (Service Set Identification)
must be assigned to all wireless devices in your network. Considering your wireless network
security.
Channel width - Select the channel width from the pull-down list
40MHz.
Note:
If 2.4GHz (B), 2.4GHz (G), or 2.4GHz (B+G) is selected in the Mode field, the Channel
Width selecting field will disappear and the value will become 20M, which is unable to
be changed.
Control Sideband – Select the sideband with upper or lower for channel width 40MHz.
Channel Number- This field determines which operating frequency will be used. The default
channel is CH11. You can set to Auto where the AP will choose the best channel
automatically, it is not necessary to change the wireless channel unless you notice
interference problems with another nearby access point.
Broadcast SSID - When wireless clients survey the local area for wireless networks to
associate with, they will detect the SSID broadcast by the router. If you select Enable for
Broadcast SSID then router will broadcast its name (SSID) on the air.
WMM – Click on Enable or Disable Wireless Multimedia (WMM).
Data Rate - Select transmission data rate from pull-down menu. Data rate can be auto
select, 1M to 54Mbps or MCS. The default option is AUTO.
- 30 -
AIP-W512
.
The default setting is
Advertisement
Table of Contents
