Table of Contents
Advertisement
Set DNS Manually - If your ISP gives you one or two DNS addresses, select Set DNS
Manually and enter the primary and secondary addresses into the correct fields. Otherwise,
the DNS servers will be assigned dynamically from your ISP.
Note:
If you find an error message on the website after entering the DNS addresses, it is likely
that your DNS server has been set up improperly. You should contact your ISP to get
DNS server addresses.
If your ISP provides a PPPoE connection, select PPPoE option and enter the following
3.
parameters (Figure 4-9):
User Name/Password - Enter the User Name and Password provided by your ISP. These
fields are case-sensitive.
Service Name - The service name should not be configured unless you are sure it is
necessary for your ISP. In most cases, leaving these fields blank.
Connection Type
Continuous – Continuous connection type means to setup the connection through
PPPoE protocol whenever this WLAN Broadband router is powered on.
Figure 4-9
WAN setting - PPPoE
- 23 -
AIP-W512
Advertisement
Table of Contents
