• Duct Work - GE JP989 Owner's Manual & Installation Instructions

TOOLS AND MATERIALS
YOU WILL NEED
• Saw
• Flat blade screwdriver
• Electrician's pliers
• Duct tape
• Measuring tape or scale
• Carpenter's square
• 7/16" wrench or socket set
• Drill and drill bit
• Sheet metal screws
• Junction box*
• 1/2" flexible conduit*
• Electrical wire per local code*
• Wire nuts*
• Duct work
*NOTE: Electrical installation kit JXCK89 may be
ordered separately and includes all the parts necessary
to connect the cooktop to typical rough-in wiring.
CAUTION: –
REMOVE HOUSE FUSE OR CIRCUIT BREAKER
BEFORE BEGINNING INSTALLATION.
Installation Instructions
PREPARATION
FOR PERSONAL SAFETY,
30" Cooktop (Dimensions for reference only)
Unit shown fully assembled.
Unit must be vented to the outside!
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the proper
voltage and frequency, as listed in these Installation
Instructions, and connected to an individual, properly
grounded branch circuit, protected by a 40-amp circuit
breaker or time delay fuses.
All wire connections must be made in accordance
with local codes and properly insulated. Check with
your local utility for governing electrical codes and
ordinances. In the absence of local electrical codes, the
National Electrical Code, ANSI/NFPA No. 70 – Latest
Edition, governing electric range installations, must be
followed.
A copy of the National Electrical Code can be
obtained by writing to:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02260
Effective January 1, 1996, the National Electrical Code
requires that new, but not existing, construction utilize
a four-conductor connection to an electric range.
When installing an electric range in new construction,
follow the instructions in NEW CONSTRUCTION
AND FOUR-CONDUCTOR BRANCH CIRCUIT
CONNECTION.
You must use a three-wire, single-phase AC 208Y/120
Volt or 240/120 Volt, 60 Hertz electrical system with
separate ground. If you connect to aluminum wiring,
properly installed connectors approved for use with
aluminum wiring must be used.
"
21 7 ⁄
8
22"
6"Dia.
"
20 ⁄
1
2
15
"
29 7 ⁄
8
6"
"
28 3 ⁄
4