• Duct Work; Electrical Requirements - GE JP989 Owner's Manual & Installation Instructions

TOOLS AND MATERIALS
YOU WILL NEED
• Saw
• Flat blade screwdriver
• Electrician's pliers
• Duct tape
• Measuring tape or scale
• Carpenter's square
• 7/16" wrench or socket set
• Drill and drill bit
• Sheet metal screws
• Junction box*
• 3/4" flexible conduit*
• Electrical wire per local code*
• Wire nuts*
• Duct work
*NOTE: Electrical installation kit JXCK89
may be ordered separately and includes all
the parts necessary to connect the cooktop
to typical rough-in wiring.
CAUTION:
FOR PERSONAL SAFETY,
REMOVE HOUSE FUSE OR CIRCUIT
BREAKER BEFORE BEGINNING
INSTALLATION.
30" COOKTOP (DIMENSIONS FOR REFERENCE ONLY)
Installation Instructions
PREPARATION
Unit shown fully assembled.
Unit must be vented to the outside!
15

ELECTRICAL REQUIREMENTS

This appliance must be supplied with the proper
voltage and frequency, as listed in these Installation
Instructions, and connected to an individual,
properly grounded branch circuit, protected
by a 40-amp circuit breaker or time delay fuses.
All wire connections must be made in accordance
with local codes and properly insulated. Check with
your local utility for governing electrical codes and
ordinances. In the absence of local electrical codes,
the National Electrical Code, ANSI/NFPA No. 70 –
Latest Edition, governing electric range installations,
must be followed.
A copy of the National Electrical Code can be
obtained by writing to:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02260
Effective January 1, 1996, the National Electrical
Code requires that new, but not existing,
construction utilize a four-conductor connection to
an electric range. When installing an electric range
in new construction, follow the instructions in NEW
CONSTRUCTION AND FOUR-CONDUCTOR
BRANCH CIRCUIT CONNECTION.
You must use a three-wire, single-phase AC
208Y/120 Volt or 240/120 Volt, 60 Hertz electrical
system with separate ground. If you connect to
aluminum wiring, properly installed connectors
approved for use with aluminum wiring must
be used
.
"
21 7 ⁄
8
22"
"
20 1 ⁄
2
"
29 7 ⁄
8
6"
"
28 3 ⁄
4