Figure 6: Method 1 - Configure Fxo Port On The Gxw410X: Sip Settings; Figure 7: Method 1 - Configure Fxo Port On The Gxw410X: Dtmf Method; Figure 8: Method 1 - Configure Fxo Port On The Gxw410X: Dtmf Payload Type; Figure 9: Method 1 - Configure Fxo Port On The Gxw410X: Fxo Termination - Grandstream Networks UCM6100 User Manual

Configuring ucm6100 with gxw410x

Hide thumbs Also See for UCM6100:

Table of Contents

Figure 6: Method 1 - Configure FXO Port on the GXW410X: SIP Settings

Since we are going to use IVR when the call is forwarded to the UCM6100, UCM6100 will need to be

able to detect the DTMF digits. Configure the GXW410X FXO port DTMF settings as below for the

initial setup. This can be found under Settings-> Channel Settings.

Set the DTMF Payload Type to 101. This value can be found under Settings->Call Settings.

There are few changes to be made in FXO termination section. This feature can be found under FXO

Lines settings page.

CONFIGURING UCM6100 WITH GXW410X

Page 8 of 13

Table of Contents