Oil Filter Rubber Seal View - Honda XL700V Owner's Manual

•
4. Apply a thin coat of engine oil to the
new oil filter rubber seal (4).
5. Using a special tool and a torque
wrench, install the new oil filter and
tighten to a torque of:
26 N·m (2.7 kgf·m, 20 IbUt)
Use only the Honda genuine oil filter or a
filter of equivalent quality specified for
your model. Using the wrong Honda filter
or a non-Honda filter which is not of
equivalent quality may cause engine
damage.
(4)
(4) Oil filter rubber seal
104
6. Check that the sealing washer on the
drain plug is in good condition and
install the plug. Replace the sealing
washer every other time the oil is .
changed, or each time if necessary.
Engine oil drain plug torque:
30 N·m (3 .1 kgf·m , 22 Ibf·ft)
7. Fill the crankcase with the recommended
grade oil; approximately:
2.3 I (2.4 US qt, 2.0 Imp qt)
8. Install the oil filler cap/dipstick.
9. Install the under cowl.
10. Start the engine and let it idle for 3-5
minutes.
11 . 2-3 minutes after ·stopping the engine,
check that the oil level is at the upper
level mark on the oil filler cap/dipstick
with the motorcycle upright on firm,
level ground. Make sure there are no
oil leaks.
CD