Hazard Switch - Honda XL700V Owner's Manual

Hazard Switch (5)
The Hazard should be used only when
y our motorcycle is stopped under
emergency or hazardous conditions. To
turn it on, turn the ignition key to the ON
p osition, and then push the switch
marked
A .
The front and rear turn signals
will blink simultaneously.
All of the signals can blink without the
ignition key.
To operate this function , proceed as
follows:
1. Turn the ignition key to ON position
and then push the hazard switch.
2. All of the turn Signals will keep blinking
even after you turn the ignition key to
OFF or LOCK position.
3. You can turn off the turn blinking
signals by pushing the hazard switch
again to the off position.
Be sure to turn the switch off when the
hazard warning is no longer required , or
the turn Signals will not work properly, and
may confuse other drivers.
If all the turn signals are left blinking with
the engine stopped , the battery will be
discharged.
(5)
(5) Hazard switch
67
I