Settings Menu; Level One Settings Menu; Remaining Credit; Dose Settings - LAVAZZA LB 2500 PLUS Instructions For Use Manual

To access and navigate the items within the Set-
tings Menu please use the following functions on
the selection keypad which are each assigned to a
separate button.
Enter
Esc
To access the Settings Menu please start the ma-
chine by pressing and holding the "Enter" button
for approximately 3 seconds. At this point the dis-
play will show:

SETTINGS MENU

After confirming with "Enter", a password will be
requested.
PASSWORD
If you do not have a password, it will only be pos-
sible to access the level one menu.
Password knowledge on the other hand allows ac-
cess to the level two menu.

LEVEL ONE SETTINGS MENU

1
Press "Enter". You can navigate between the
following items in the level one menu by using
buttons 4 and 5.

Remaining credit

➤

Dose settings

➤
REMAINING CREDIT
By confirming the "Remaining Credit" item with
"Enter", an indication of the remaining supplies still
available from the machine will appear on the dis-
play.
LAVAZZA LB PLUS
CREDIT 00050
SETTINGS MENU
4
1
2 5
3 6
Press the "Esc" button one or more times to go back
to previous menu levels or to exit the menu.
DOSE SETTINGS
By confirming the "Dose Settings" item with "Enter",
you can change, within preset limits, the different
selection parameters.
In fact the lower level menu allows you to choose
the selection you want to change using buttons 4
and 5.
Product 1
➤
. .
➤
. .
➤
Product 6
➤
Selection of a product with the "Enter" button, then
using the 4 and 5 buttons, gives the following pa-
rameters for which the default values are:
Offset pumps
➤
(allows you to change the pump activation time)
Offset TR1
➤
(allows you to change the hopper activation
time).
The item is displayed for all the products but is
active only for the products which require solu-
ble powder.
By selecting one of the parameters with the "Enter"
button the display will show:
SET UP OK
You can then change the default value using the 4
and 5 buttons.
Every time you press the buttons the activation
time for the parameter you are changing increases
or decreases by 0.5 seconds.
Only in the case of the pumps, if the settings have
been programmed on the basis of dose, a 0.5 in-
crease or decrease corresponds to a dose increase
step calculated in cc.
The selection can then be confirmed using the
"Enter" button. Press the "Esc" button one or more
times to go back to previous menu levels or to exit
the menu.
E N
0
21