Connect Charge Protection; Instructions For Lanconfig - Lancom DSL Series Manual

LANCOM Wireless DSL – LANCOM Wireless ADSL
Chapter 3: Basic configuration
3.1.6

Connect charge protection

Connect charge protection blocks connections that go beyond a previously set
amount, protecting you from unexpectedly high connection costs.
In LANCOM Wireless DSL, there are three independent budgets: For DSL
access, you can set a maximum connection time in minutes. In addition to this
time budget, there is also a budget for limiting ISDN connection charges.
Any budget can be deactivated by entering the value '0'.
It is possible to completely turn off connect charge protection
3.2

Instructions for LANconfig

38
vider. They are normally entered without an area code. These numbers are
only relevant for the router functions (LAN to LAN coupling, RAS), not for
remote configuration and LANCOM VPN Option.
A dialing prefix for access to the public telephone network. This is nor-
mally required only when using an ISDN PBX. '0' is the usual prefix. It is
used for all outgoing calls.
Finally, you should know whether your telephone provider transmits an
ISDN connect-charge pulse. This signal can be used LANCOM Wireless
DSL for connect-charge budgets and the accounting function.
In order for the limitations according to connect charge rates to func-
tion properly, it is necessary to enter the information for connect
charge rates through ISDN.
In basic settings the charge protection is defined to maximum 600
minutes within seven days. Adapt this setting to your personal needs
or deactivate the charge protection if you have arranged a flatrate
with your provider.
Start up LANconfig by clicking Start
LANconfig
LANconfig automatically detects the new LANCOM Wireless DSL in the
TCP/IP network. Then the setup wizard starts that will help you make the
basic settings of the device or will even do all the work for you (provided
a suitable network environment exists).
Programs LANCOM