Table of Contents
Advertisement
7.13.2 Engine oil – Level check
Preconditions
☑ Engine is stopped and starting disabled.
Checking oil level prior to engine
start
1.
Withdraw oil dipstick from guide tube and
wipe it.
2.
Insert oil dipstick into guide tube up to stop,
withdraw after approx. 10 seconds and
check oil level.
Note:
After extended standstill, the oil level may
exceed the mark (1) by up to 2 cm. This
can be caused by oil flowing from e.g. oil fil‐
ter or heat exchanger back to the oil pan.
3.
The oil level must reach mark (1) or exceed
mark (1) by up to 2 cm.
4.
Top up with oil to mark (1) as necessary
(→ Page 167).
5.
Insert oil dipstick into guide tube up to the
stop.
Checking oil level after the engine is stopped
1.
5 minutes after stopping the engine, remove oil dipstick from the guide tube and wipe it.
2.
Insert oil dipstick into guide tube up to stop, withdraw after approx. 10 seconds and check oil level.
3.
Oil level must be between marks (1) and (2).
4.
Top up with oil to mark (1) as necessary (→ Page 167).
5.
Insert oil dipstick into guide tube up to the stop.
M015710/04E 2012-09 | Task Description | 169
Hide quick links:
Advertisement
Table of Contents
