MTU M015710/04E Operating Instructions Manual page 124

Checking diaphragm
1. Remove cover (4).
2. Remove spring (5), gasket (2) and dia‐
phragm (3).
3. Check diaphragm (3) for damage, fit new
diaphragm if used one is damaged.
4. Install diaphragm (3) on housing (1).
5. Install new seal (2) and spring (5) together
with cover (4).
6. Use torque wrench to tighten the screws of cover (4) to the specified torque.
Name
Screw
7. Check diaphragms in further oil separators in the same way.
Size Type
Tightening torque
Lubricant
(Engine oil)
M015710/04E 2012-09 | Task Description | 139
Value/Standard
10 Nm −2 Nm