Fisher & Paykel RS36W80 series Installation Instructions Manual page 32

For custom toe tick greater than 4" (102mm)
Measure the required height for the bottom grille. On a board, carefully score/cut
1
the un-required vanes from the bottom of the kickstrip grille and discard (refer to A).
Drill Ø 5/32" (4mm) holes into the dimples of the grille (refer to B).
2
Repeat this process for all dimples.
Cut un-required vanes from the bottom of the grille
Grille tabs
With the grille tabs facing upwards, align the grille to the bottom of the plinth where the
3
screw holes are located and secure with screws x3 (#8 x 5/8" pan head screws) (refer to C).
Align the air flow divider underneath the grille tabs indicator and clip onto the vanes of the
4
bottom grille (refer to D).
30
DETAIL D
!9 ATTACH BOTTOM GRILLES
B
A
C
Front right view
DETAIL B
SCALE 2 : 5
For toe kick installation at 4" (102mm)
With the grille tabs facing upwards, align the grille clips to the bottom of the plinth's slots,
1
DETAIL A
then firmly push grille onto the plinth (refer to A).
SCALE 1 : 1
DETAIL A
SCALE 1 : 1
1.
2.
3.
Align the air flow divider underneath the grille tabs indicator and clip onto the vanes of the
2
bottom grille (refer to B).
D
A
Grille tabs
DETAIL A
SCALE 1 : 1
IF TOEKICK IS HIGHER THAN 4" USE SIDE CUTTER TO
CUT UNREQUIRED VANES FROM DOTTOM
DRILL HOLES THROUGH DIMPLES
USE PROVIDED SCREWS TO FIX GRILL TO
MATCHING HOLES ON PLASTIC PARTS
DETAIL D
SCALE 2 : 1
B
DETAIL D
SCALE 2 : 1