Fisher & Paykel RS36W80 series Installation Instructions Manual page 27

For Fisher & Paykel EZKleen stainless steel and DCS stainless steel door panels only.
Remove the external display
1
module from inside the product.
Thread the display harness
through the door panel cavity.
Ensure the grommet is engaged.
Angle top display tabs into the
2
door panel. Ensure the harness
is free of pinching. Firmly push
against bottom display tabs
and insert into the door panel
until you feel it clip securely.
Ensure the display is flush with
the door panel.
Remove water tube from holder
3
on the refrigerator door.
Hang door panel onto M8 studs.
4
Ensure the panel is free to pivot
for water connections (refer to A).
!4 HANG ICE & WATER DOOR PANEL
Connect display harness
5
onto the refrigerator door
by inserting firmly until
you feel it clip securely
(refer to B).
On the external display,
enable the dispenser lock,
this will help prevent any water
from dispensing during water
connection. To lock, press the
for 4 seconds. The LED above the button
will illuminate.
A
Firmly push the water
6
tube into the spigot
behind the door panel
until the marked line is not
visible.
Ensure the water tube is routed away from
any sharp objects, sharp corners, and not
in a location where it can be kinked or
squashed when the door panel is secured,
(as this will stop water flow).
Flush water filtration system. See page 27.
To secure door panel, follow the instructions
in the next section: 'Hang non-Water
dispensing door panels'.
B
button
25