Table of Contents
Advertisement
4.4 - INSTALLATION: Control unit
(models HSCU1GC - HSCU1C and HSCU1G - HSCU1)
4.4.1 - Warnings
Before proceeding with installation carefully read paragraphs 4.1 - 4.2 - 4.3.
4.4.2 - INSTALLATION
01. Remove the protection grille (fig. 7-A) and the cover (fig. 7-B) to open the
housing;
02. Unhook the side hook so that the body of the control unit can be rotated
(fig. 8);
03. Insert the memory board supplied; ensure that it is correctly inserted in the
internal connector guides (fig. 9).
On control unit models HSCU1GC and HSCU1G (with GSM) also
insert the SIM card (fig. 10).
04. Before fixing the housing, the "anti-lever" system can be activated if
required on the rear tampering detector (fig. 11):
a) remove part "a" as shown and set aside
b) remove part "b" as shown and throw it away;
05. For models HSCU1GC and HSCU1C: make a hole for the cables (fig.
12) and route the electric power cables through the hole (fig. 13);
06. Refit the control body unit in its seat (fig. 14);
07. Mark the 3 fixing points shown in fig. 15 on the wall. If the "anti-lever" sys-
tem has been activated also mark the 4th point for part "a" (fig. 15);
08. Drill holes in the wall at the 3 fixing points and insert the screws and plugs
supplied (fig. 16). If the "anti-lever" system has been activated also drill a
hole at the 4th point and insert the plug and part "a", previously set aside
(fig. 16);
7A
9
7B
x 4
09. Fix the control unit to the wall using the screws supplied (fig. 17);
10. Electrical connections:
• For models HSCU1GC and HSCU1C:
make the electrical connections and insert the buffer battery as described
in chapter 5.
• For models HSCU1G and HSCU1:
connect the battery pack as shown in fig. 18;
11. Close the housing (fig. 19).
12. Now proceed with the installation of the various devices as envisaged (see
paragraph 4.5) and program the control unit (see chapter 6).
8
10
11
Advertisement
Table of Contents
