Inner Door Removal Procedure (cont.)
Step 5.
Remove (2) 1/4" drive screws from the left side inner door.
Step 6.
Remove the connectors attached to the resettable thermal switch on the
right side inner door.
Connectors attached to reset-
table thermal switch
Step 7.
Inspect both inner doors for any of the following imperfections: tears,
missing material, cracks, dirt or debris, lack of adhesion to the inner door, material left
on combustion chamber, or any other imperfections that will inhibit a proper seal.
If any of the imperfections above are present, replace the inner door gasket following
the Inner Door Gasket Replacement Procedure. If not, replacement of the inner door
gaskets is not necessary.
Left side inner door
1/4" hex drive
screws
Inner Door Removal
Page 29
29