Use; Cutting Hair - Silvercrest SHBS 600 A1 Operation And Safety Notes

Before getting started / Use
j
T o charge the device, push the ON / OFF switch
j
I nsert the adaptor cable into the port
the AC adaptor plug into a suitable socket (100 - 240 V ~ ).
The state-of-charge display (LED)
process.
The state-of-charge display (LED)
If the rechargeable battery is fully charged, the hair and beard trimmer can be used for at
least 60 minutes without any mains power.
Note: If the rechargeable battery is nearly flat, the state-of-charge display (LED)
change colour from green to red. The hair and beard trimmer will work only for a short time.

Use

Q
Tip: The hair to be cut should be clean and dry.
j
C omb your hair through carefully to remove any knots.
j
P lace the hairdresser's cape or a cloth around the throat and neck to prevent hair from
dropping into the collar.

Cutting hair

Q
Tip: First cut the hair to a longer length than is required, then proceed in stages until you
achieve the desired length.
j
S elect and insert a comb attachment
cut to the following lengths: 4 / 7 / 10 / 13 / 16 mm and 18 / 21 / 24 / 27 / 30 mm.
j
P ush the attachments onto the hair and beard trimmer over the lateral guide rails.
j
P ush the comb attachment
click into place.
j
A djust the desired cutting length by pushing the slide for the comb attachment
j
S witch on the hair and beard clippers by pushing the ON / OFF switch
j
R un the hair and beard clippers slowly though your hair.
j
I n order to cut straight with a cutting length of more than 20 mm, the hair and beard trimmer
should be guided through the hair several times from different directions.
j
W hen doing so, hold the hair and beard clippers in such a way that the comb attachment
lies as flat as possible.
j
A lways cut from the nape of the neck in the direction of the top of the head or from the
forehead and temples upwards towards the centre of the head.
12 GB
on the hair and beard trimmer and then insert
7
will flash red and shows the state of the charging
6
will flash green when the charging process has finished.
6
. Select between comb attachments
1
onto the comb attachment mounting
1
down to the OFF position.
5
4
will
6
that can
1
until you hear it
.
9
up.
5
1