Operation; Pushing On/Removing The Comb Attachments; Cutting Hair - Silvercrest 93480 Operating Instructions Manual

__GRA93480_B4.book Seite 8 Montag, 9. September 2013 9:12 21

6. Operation

Regardless of the charging state of the battery, the hair and beard trimmer can
always be mains-operated.
1. Before switching to mains operation, ensure that the device is switched off.
2. Connect the power unit to the connection|7 of the device.
3. Insert the power unit into a readily accessible wall socket whose voltage
matches the voltage stated on the rating plate.
4. Switch on the device with the on/off switch|5.

6.1 Pushing on/removing the comb attachments

WARNING! Risk of injury!
Switch off the device before replacing or changing the comb attachments.
Pushing on
• In order to attach a comb attachment, push this over the guide rails on the
side of the device onto the comb attachment fastener|4, until it is heard to
click into place.
Removing
1. Figure A: To change the comb attachments, turn the device onto its back.
2. Figures B/C: Push the comb attachment|1 upwards together with the slid-
er|10. Push the comb attachment carefully upwards with moderate force us-
ing your thumb and index finger beyond the side locking pins. The comb
attachment is released from the comb attachment fastener|4.
3. Remove the comb attachment.

6.2 Cutting hair

NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depending on the cutting angle.
• Place a sheet or cape around throat and neck to prevent cut-off hair from
dropping into the collar.
• Comb the hair well.
• First, start with a comb attachment with a longer cutting length and then, in
the course of the cutting process, use shorter cutting lengths step by step. Ad-
GB
8