Chemical Safety - Toro 41593 Operator's Manual

•
Before operating the sprayer, always check the designated
areas of the sprayer that are stated in the Pre-Starting
Checks in the Operation section. If the machine does
not function correctly or is damaged in any way, do not
use the sprayer. Make sure that the problem is corrected
before the sprayer or attachment is operated.
•
Make sure the operator and passenger area is clean and
free from chemical residue and debris buildup.
•
Ensure that all fluid line connectors are tight and all hoses
are in good condition before applying pressure to the
system.
Note: Do not use the sprayer if it is leaking or damaged.
•
Since fuel is highly flammable, handle it carefully.
– Use an approved fuel container.
– Do not remove the cap from the fuel tank when the
engine is hot or running. Allow the engine to cool
before fueling the machine.
– Do not smoke while handling fuel.
– Fill the fuel tank of the machine outdoors.
– Fill the fuel tank of the machine to about 25 mm (1
inch) below the top of the tank (the bottom of the
filler neck). Do not overfill the fuel tank.
– Wipe up any spilled fuel.

Chemical Safety

WARNING
Chemical substances used in the spreader-sprayer
system may be hazardous and toxic to you,
bystanders, animals, plants, soils or other property.
• Carefully read and follow the chemical warning
labels and Material Safety Data Sheets (MSDS)
for all chemicals used and protect yourself
according to the chemical manufacturer's
recommendations. Ensure that as little skin
as possible is exposed while using chemicals.
Use appropriate Personal Protective Equipment
(PPE) to guard against personal contact with
chemicals, such as:
– safety glasses, goggles, and/or face shield
– respirator or filter mask
– chemical resistant gloves
– rubber boots or other substantial footwear
– hearing protection
– clean change of clothes, soap, and disposable
towels, to be kept on-hand, in the event of
a chemical spill.
• Keep in mind that there may be more than
one chemical used, and information on each
chemical should be assessed.
• Refuse to operate or work on the sprayer if this
information is not available!
• Before working on a sprayer system, make
sure that the system has been triple rinsed and
neutralized according to the recommendations
of the chemical manufacturer(s) and all of the
valves have been cycled 3 times.
• Verify there is an adequate supply of clean water
and soap nearby, and immediately wash off any
chemicals that contact you.
•
Obtain proper training before using or handling
chemicals.
•
Use the correct chemical for the job.
•
Follow the chemical manufacturer's instructions for
the safe application of the chemical. Do not exceed
recommended system application pressure.
•
Do not fill, calibrate, or clean the unit when people,
especially children, or pets are in the area.
•
Handle chemicals in a well ventilated area.
•
Have clean water available especially when filling the
spray tank.
•
Do not eat, drink, or smoke while working with chemicals.
5