Table of Contents
Advertisement
Sprayer Controls
Figure 12
1. Oil pressure and battery
light
2. Water temperature and
glow plug light
3. Pressure gauge
Application Rate Switch
The application rate switch is located on the dash to the right
of the steering wheel
(Figure
forward to increase the spray system pressure, or press and
hold it rearward to decrease pressure.
4. Dash controls for optional
kits
5. Key and key switch
14). Press and hold the switch
Pressure Gauge
The pressure gauge
(Figure
gauge shows the pressure of the fluid in the system in psi
and kPa.
Master Boom Switch
The master boom switch is located on the floor board of the
machine cab and to the left of the operator. It allows you to
start or stop the spray operation. Press the switch with your
foot to enable or disable the spray system
1. Master boom switch
Section Switches
The section switches are located on the control panel to the
right of the seat
(Figure
turn the corresponding boom section on and rearward to
turn each off. When the switch is in the On position, a light
will illuminate on the switch. These switches will only affect
the spray system when the master boom switch is in the On
position.
Pump Switch
The pump switch is located on the control panel to the right
of the seat
(Figure
14). Toggle this switch forward to run
the pump or rearward to stop the pump. When the switch is
turned on, a light on the switch illuminates.
Important: Only engage the pump switch when the
engine is at low idle to avoid damaging the pump drive.
Boom Lift
The boom lift switches are located on the control panel to the
right of the seat and used to raise the left and right booms
respectively
(Figure
14).
18
12) is located on the dash. This
(Figure
13).
Figure 13
14). Toggle each switch forward to
Advertisement
Table of Contents
