Table of Contents
Advertisement
Figure 84
Agitation Valve Manifold
1. Stem retainer
2. Valve stem
3. Stem port
4. Stem capture retainer
5. Endcap fitting
6. Endcap seal O-ring (0.796
inch / 0.139 inch)
7. Back seating O-ring (0.676
inch / 0.07 inch)
8. Valve seat ring
9. Mainfold body
10. Ball valve
11. Endcap fitting assembly
Section Valve Manifold
1. Valve stem seat
2. Valve stem assembly
3. Stem port
4. Stem retainer
5. Outlet fitting O-ring (0.737
inch / 0.103 inch)
6. Endcap fitting
3. Turn the valve stem so that the ball is in the open
position (A of
Figure
Note: The valve stem will be parallel with the valve
flow and the ball will slide out.
4. Remove the stem retainer from the slots in the stem
port in the manifold
5. Remove the stem retainer and valve stem seat from the
manifold
(Figure 84
6. Reach into the manifold body and remove the valve
stem assembly
(Figure 84
7. Clean the inside of the manifold and exterior of the
ball valve, valve stem assembly, stem capture, and end
fittings.
62
Figure 85
7. Endcap O-ring (0.796 inch
/ 0.139 inch)
8. Back seating O-ring (0.676
inch / 0.07 inch)
9. Ball seat
10. Mainfold body
11. Ball valve
12. Endcap fitting assembly
83).
(Figure 84
and
Figure
85).
and
Figure
85).
and
Figure
85).
Advertisement
Table of Contents
