Power Supply - CBC CL-301 Instruction Manual

1. Power supply

(1) Use only with a 24VAC power supply marked class 2 or 12VDC regulated power supply.
(2) Be sure to connect each lead to the appropriate terminal. Wrong connection may cause mal-
function and / or damage to the camera.
2. Operating and storage locations
(1) Do not attempt to aim the camera at the sun or other extremely bright objects that cause smear
to appear irrespective of whether the camera is operating or not. This can damage the CCD
(Charge Coupled Device).
(2) Do not place the camera in the following locations.
q Locations subjected to extremely high or low temperatures.
(operating temperature range : –10°C to +50°C {14°F to 122°F})
(storage temperature range : –20°C to +60°C {–4°F to 140°F})
w Locations subjected to high levels of humidity and dust
(storage humidity range : max 85% {no condensation})
e Locations where there are large amounts of water vapour and steam
r Locations subjected to excessive vibrations
(3) When this camera is installed near equipment, like a wireless communication device, that emits a
strong electromagnetic field, some irregularity such as noise on the monitor screen may happen.
3. Handling of the unit
Do not allow the camera to be subjected to strong impacts or shocks. The camera could be
damaged by improper handling or storage.
-Never attempt to disassemble or modify the camera.
-If an abnormality should occur, immediately turn off the power and consult your dealer.
-Never open the housing of any power supply during cleaning.
-After installation, ensure that all cables are laid in such a way that they cannot be kinked or
crushed or damaged in any other way.
EG-4