Contact With Liquid; Questions And Answers; Specifications - Siemens Gigaset A160 Instructions Manual

Appendix
Entering special characters
Standard characters
1x 2x
1
1
Space
Q
. ,
P
* /
#
Abc--> 123-->
123 abc
Greek
1x 2x
1
1
Space
Q
. ,
P
* /
#
Abc--> 123-->
123 abc

Specifications

Recommended battery pack
(Valid at the time of going to press)
Nickel-metal-hydride (NiMH):
Handset A16: V30145-K1310-X383, -X359
Handset A26: V30145-K1310-X359, X402
The handset is supplied with the recommended
battery pack.
Base station power consumption
In standby mode: approx. 2W
During a call: approx. 3W
General specifications
DECT standard
GAP standard
Range
Base station power sup-
ply
Environmental conditions
in operation
3x 4x 5x 6x
£ $ ¥
? ! 0
( ) <
# @ \
3x 4x 5x 6x
£ $
? ! 0
( ) <
# @ \
is supported
is supported
up to 300 m outdoors,
up to 50 m in buildings
230 V ~/50 Hz
+5 °C to +45 °C;
20% to 75% humidity
9
Care
Wipe the base station, charging cradle and
handset with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause static.
¤

Contact with liquid

+
= If the handset has come into contact with liquid:
1 Switch off the handset and remove the bat-
&
tery pack immediately.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours (not in a microwave, oven etc.).
4 Do not switch on the handset again until it is
+
completely dry.
=
When it has fully dried out, you will normally be
able to use it again.
&

Questions and answers

If you have any queries about the use of
your phone, you can contact us any time at
www.gigaset.com/customercare. The table below
contains a list of common problems and possible
solutions.
Problem
Nothing
appears in the
display.
No reaction to
keystroke.
No wireless
connection to
the base sta-
tion, Base
flashes in the
display.
!
Cause Solution
The handset is Press the end call key
a
not switched on. for approx. 5
seconds or place the
handset in the base
station.
Battery pack is Charge/replace the
flat. battery pack (page 3).
The key lock is Press the hash key
activated. for approx. 2 sec
(page 1).
The handset is Move the handset
outside the range closer to the base
of the base sta- station.
tion.
The handset is Register the handset
not registered. (page 3).
The base station Check the power con-
is not switched nector at the base
on. station (page 2).
Check cord routing
Cords not routed (page 2).
correctly
R