Listening To The Radio; Am Frequency Step Setup (On Some Models) - Onkyo HT S5100 Instruction Manual

Listening to the Radio

AM Frequency Step Setup
(on some models)
2, 3
1, 5
For AM tuning to work properly, you must specify the
AM frequency step used in your area. Note that when
this setting is changed, all radio presets are deleted.
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
2
Use the Up and Down [
buttons to select "0.Hardware-
Setup," and then press [ENTER].
3
1
2–4
4
5
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
]/[ ]
Use the Up and Down [
buttons to select "AM Freq."
Use the Left and Right [
buttons to select:
10kHz: Select if 10kHz steps are used
in your area.
9kHz: Select if 9kHz steps are used
in your area.
Press the [SETUP] button.
Setup closes.
]/[ ]
]/[ ]
51