Table of Contents
Advertisement
HT-S780_En.book Page 36 Monday, February 28, 2005 2:13 PM
Using the Tuner
Listening to the Radio
STANDBY/ON
STANDBY
A SPEAKERS B
TONE
+
STEREO
LISTENING MODE
PHONES
PURE AUDIO
MULTl CH
DVD
VIDEO 1
VIDEO 2
VCR
With the built-in tuner, you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
1
Use the [TUNER] input selector
TUNER
button to select either AM or FM.
In this example, FM has been selected.
Band
(Actual display depends on country.)
AM Frequency Step Setup
(not North American model)
Here you can specify the AM frequency step used in
your area. When this setting is changed, all radio presets
are deleted.
1
Press the [SETUP] button and
use the Up and Down [
buttons to select "0. Hardware
Setup," and then press [ENTER].
2
Use the Up and Down [
buttons to select "AM Freq," and
then use the Left and Right
[
]/[
10 kHz: Select if 10 kHz steps are
9 kHz: Select if 9 kHz steps are used
3
Press the [SETUP] button.
Setup closes.
Note:
• This procedure can also be performed on the remote
controller by using its [SETUP] button, arrow buttons,
and [ENTER] button.
36
TUNING MODE
TUNING
TUNING / PRESET
MASTER VOLUME
ENTER
RETURN
SETUP
DISPLAY DIGITAL INPUT
RT/PTY/TP MEMORY TUNING MODE
CLEAR
VIDEO 3 INPUT
VIDEO
L
AUDIO
R
VIDEO 3
TAPE
TUNER
CD
TUNER
Frequency
]/[
]
]/[
]
] buttons to select:
used in your area.
in your area.
Tuning into Radio Stations
■ Auto Tuning Mode
1
Press the [TUNING MODE] button
TUNING MODE
so that the AUTO indicator
appears on the display.
2
Press the TUNING Up or Down
[ ]/[ ] button.
TUNING / PRESET
Searching stops when a station is
found.
ENTER
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator appears on the display, as shown.
■ Manual Tuning Mode
1
Press the [TUNING MODE] button
TUNING MODE
so that the AUTO indicator disap-
pears from the display.
2
Press and hold the TUNING Up or
Down [ ]/[ ] button.
TUNING / PRESET
The frequency stops changing when
ENTER
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
The American model changes FM frequency in 0.2 MHz
steps, 10 kHz steps for AM. For other models it's
0.05 MHz steps for FM and 9 kHz steps for AM.
In Manual Tuning mode, FM stations will be in mono.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
TUNED
AUTO
FM STEREO
Advertisement
Table of Contents
