Listening To The Radio; Listening To Am/Fm Stations - Onkyo HT-SP904 Instruction Manual

Listening to the Radio

Listening to AM/FM Stations

STANDBY/ON
STANDBY
MULTI CH DVD
PHONES
DISPLAY DIGITAL INPUT TONE
With the built-in tuner, you can enjoy AM and FM radio
stations.
1 Use the [TUNER] input selector
button to select AM or FM.
In this example, FM has been selected.
TUNER
(Actual display depends on country.)
44
TUNER
TUNING
TUNING PRESET
VCR/DVR CBL/SAT AUX TAPE TUNER C D
SETUP ENTER RETURN
SETUP MIC
STEREO LISTENING MODE DIMMER MEMORY TUNING MODE
CLEAR
TUNING MODE
Band Frequency
Tuning into AM/FM Radio Stations
■ Auto Tuning Mode
1
TUNING MODE
MASTER VOLUME
AUX INPUT
VIDEO L AUDIO R
2
TUNING PRESET
■ Manual Tuning Mode
1
TUNING MODE
2
TUNING PRESET
The American model changes FM frequency in 0.2 MHz
steps, 10 kHz steps for AM. For other models it's
0.05 MHz steps for FM and 9 kHz (or 10 kHz) steps for
AM.
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator also appears.
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Note:
• You can also use the remote controller's Up and Down
[ ]/[
Press the [TUNING MODE] button
so that the AUTO indicator
appears on the display.
Press the TUNING Up or Down
[ ]/[ ] button.
Searching stops when a station is
found.
Press the [TUNING MODE] button
so that the AUTO indicator disap-
pears from the display.
Press and hold the TUNING Up or
Down [ ]/[ ] button.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
] buttons to tune the radio.
FM STEREO
AUTO
TUNED