Cleaning The Door Seal; Cleaning The Ventilation Gaps - Miele K 34472 iD Operating And Installation Instructions

Cleaning and care
 Clean the condensate channel and
drain hole frequently so that con-
densate can drain away unhindered.
Use a straw or similar to clear the
drain hole if necessary.
To do this, remove the PerfectFresh
zone compartments.
Be careful not to wash out the spe-
cial lubricant in the telescopic run-
ners during cleaning.
 The PerfectFresh zone compartments
are on telescopic runners. Clean the
telescopic runners with a damp cloth.
 Miele stainless steel conditioning
agent can be used to remove any
soiling from the stainless steel trim.
Tip: It is important to treat the stainless
steel trim with Miele stainless steel con-
ditioning agent each time it is cleaned.
This will protect the surface and help
prevent re-soiling.
 Leave the door open to air the appli-
ance for a short while and to prevent
odours building up.

Cleaning the door seal

Do not use any grease or oil on the
door seal as these will cause the seal
to deteriorate and become porous
over time.
 The door seal should be cleaned reg-
ularly with clean water, and then
wiped dry with a soft cloth.
44

Cleaning the ventilation gaps

A build-up of dust will increase the en-
ergy consumption of the appliance.
 The ventilation gaps should be
cleaned on a regular basis with a
brush or vacuum cleaner (e.g. use the
dusting brush for Miele vacuum
cleaners)
After cleaning
 Replace all shelves and accessories
in the appliance.
The left-hand shelf supports have
metal discs (contacts) which supply
power to the LED lighting.
Make sure that the contacts are clean
and dry before inserting the shelves
with LED lighting.
Push the shelf in until it clicks into po-
sition, as otherwise the lighting will not
work.
 Reconnect to the mains and switch
the appliance back on.
 Switch on the Super cool function for
a while so that the appliance can cool
down quickly.
 Place food in the appliance and close
the door.