Installation
Before installing the appliance
Take the accessory pack which in-
cludes installation parts and other ac-
cessories out of the appliance and re-
move the packaging strap holding the
door in place.
Do not remove the following from
the back of the appliance:
– The spacers (depending on model).
These ensure the gap required
between the back of the appliance
and the wall is maintained.
– Depending on model, the pouches
located in the metal grille (heat ex-
changer).
They are required for the correct
functioning of the appliance. The
contents are not poisonous or dan-
gerous.
Remove the cable clip from the back
of the appliance.
Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
62
Open the appliance door and remove
the red safety catch (depending on
model).
Does your old appliance have a dif-
ferent hinging mechanism?
If your old appliance had a different
type of hinging, the furniture door can
still be used. Remove the old hinges
from the housing unit. They are no
longer required because the furniture
door is now fitted to the appliance door.
All the necessary parts are supplied or
can be ordered from Miele.
Stainless steel front
(depending on model)
If your old appliance had different
hinging and you cannot, or do not wish
to use your old door, you can use a
stainless steel front instead.
Contact Miele for information on suit-
able stainless steel fronts.