Table of Contents
Advertisement
Cleaning and care
Touch the OK sensor control to con-
firm that the filters have been re-
placed.
The "Replace charcoal filter" reminder
will go out on the display and the
counter will be reset.
The symbol will go out on the start
display.
Cleaning the front of the appli-
ance and the side panels
If soiling is left on for any length of
time, it may become impossible to
remove. Surfaces may suffer discol-
ouration or damage.
Therefore, it is best to remove soiling
from the appliance front and side
panels immediately.
All surfaces are susceptible to
scratching. Contact with unsuitable
cleaning agents can alter or discol-
our the surfaces.
See the information on "Cleaning
agents" at the beginning of this sec-
tion.
Clean the surfaces with a clean
sponge and a solution of warm water
and washing-up liquid. A clean, damp
microfibre cloth without cleaning
agent can also be used.
After cleaning, wipe with clean water
and dry with a soft cloth.
74
CleanSteel (edt/cs) – appliance front
Risk of damage as a result of in-
correct cleaning.
The surface coating will be dam-
aged.
Do not use a stainless steel
cleaner on this surface.
The appliance front has a high quality,
special finish. This finish is resistant to
soiling and is very easy to clean.
Blackboard (bb) – appliance front
Risk of damage as a result of in-
correct cleaning.
The glass front can alter or discolour
if you spot-clean it or remove soiling
when it is dry.
Wipe the entire surface of the glass
front with a wet cloth.
Using a glass-cleaning agent con-
taining additives, e.g. citrus or sim-
ilar, would cause streaking on the en-
tire surface.
Use a glass-cleaning agent which
contains a little alcohol but no citrus
or similar additives.
Tip: We also recommend the Miele
ceramic and stainless steel cleaner.
Cleaning the door seal
Risk of damage as a result of in-
correct cleaning.
If you treat the door seal with oils or
grease, it can become porous.
Do not use any oils or grease on the
door seal.
Advertisement
Table of Contents
