Common Functions; Using Headphones; Setting The Display Brightness - Onkyo TX-SR304E Instruction Manual

TX-SR304_En.book Page 42 Tuesday, January 24, 2006 10:01 AM

Common Functions

This chapter explains functions that can be used with any input source.
TONE, –, +
STANDBY/ON
STANDBY
A SPEAKERS B TONE + STEREO LISTENING MODE
PHONES
MULTl CH DVD VIDEO 1/VCR VIDEO 2
PHONES

Using Headphones

You can connect a pair of stereo headphones (1/4-inch
phone plug) to the AV receiver's PHONES jack for pri-
vate listening, as shown.
Notes:
• Always turn down the volume before connecting your
headphones.
• Speaker sets A and B are turned off while the head-
phones plug is inserted in the PHONES jack.
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it's already set to Mono,
Stereo, or Direct.
• When the multichannel DVD input is selected, only
the front left and front right channels can be heard in
the headphones.

Setting the Display Brightness

With this function, you can adjust the brightness of the
display.
AV receiver
Press the [DIMMER] button
DIMMER
repeatedly to select: dim, dim-
mer, or normal brightness.
Alternatively, you can use the [DIM-
MER] button on the AV receiver (not
Remote
European models).
controller
DIMMER
42
TUNING / PRESET
MASTER VOLUME
ENTER
RETURN SETUP
DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE
CLEAR
VIDEO 3 TAPE TUNER CD
DIMMER
STANDBY/ON
A SPEAKERS B
PHONES
ON/STANDBY
REMOTE MODE
RECEIVER DVD
TAPE
INPUT SELECTOR
1 2 3
V 1 V 2 V 3
4 5 6
MULTI CH DVD
CDR
7 8 9
TAPE TUNER C D
+ 10
0 CLR
HDD
--/---
DIMMER SLEEP
CH
DISC
ALBUM
GUIDE PREVIOUS
Adjusting the Bass & Treble
You can adjust the bass or treble for speaker set A's front
speakers, except when the Direct listening mode is
selected.
1
Press the AV receiver's [TONE]
button repeatedly to select either
AV receiver
Bass or Treble.
TONE
Use the TONE [–]/[+] buttons to
adjust.
+
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Note:
• To bypass the bass and treble tone circuits, select the
Direct listening mode.
Press
[RECEIVER]
first
C D
MD
DIMMER
VOL