Onkyo TX-SR304E Instruction Manual page 19

TX-SR304_En.book Page 19 Tuesday, January 24, 2006 10:01 AM
Connecting Your Speakers —Continued
Connecting Speaker
1
Strip 3/8" (10 mm) of insu-
lation from the ends of the
speaker cables, and twist
the bare wires tightly, as
shown.
2
While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
The following illustration shows which speaker should be connected to each pair of terminals.
Front right Front left
speaker speaker
Speaker Set B
Connecting a Powered Subwoofer
Using a suitable cable, connect the AV receiver's SUB-
3/8" (10 mm)
WOOFER PRE OUT to an input on your powered sub-
woofer, as shown. If your subwoofer is unpowered and
you're using an external amplifier, connect the SUB-
WOOFER PRE OUT to an input on the amplifier.
Powered
subwoofer
LINE INPUT
LINE INPUT
Note:
Make sure the cable is plugged all the way.
Center speaker
Surround Surround
right
speaker speaker
Speaker Set A
Front right Front left
left speaker speaker
19