Onkyo TX-SR304E Instruction Manual page 28

TX-SR304_En.book Page 28 Tuesday, January 24, 2006 10:01 AM
Connecting Your Components —Continued
Connecting a Satellite, Cable, Set-top Box, or Other Video Source
Step 1: Video Connection
Connect your set-top box's video output jack to the AV receiver's VIDEO 2 IN jack and connect the AV receiver's
A
MONITOR OUT jack to your TV's video input jack.
If your VCR and TV have component video jacks, connect your set-top box's component video output to the AV
B
receiver's COMPONENT VIDEO VIDEO 2 IN jacks, and connect the AV receiver's COMPONENT VIDEO
OUT jacks to your TV's component video in jacks. This offers better picture quality than composite video.
Connect a coaxial feed from a TV antenna to your set-top box's antenna input jack (e.g., RF IN), and connect
C
your set-top box's antenna output jack (e.g., RF OUT) to your TV's antenna input jack.
Step 2: Audio Connection
Connect your set-top box's audio output jack to the AV receiver's VIDEO 2 IN L/R jacks.
a
If your set-top box has an optical digital audio output jack, connect it to the AV receiver's DIGITAL IN OPTI-
b
CAL 1 jack. You can enjoy Dolby and DTS listening modes with this connection.
If your set-top box has a coaxial digital audio output jack instead of an optical one, connect it to the AV receiver's
c
DIGITAL IN COAXIAL jack, and set the DIGITAL INPUT assignment to COAX (see page 33). Coaxial con-
nections perform the same as optical ones.
: Signal Flow
AV receiver
c
b
OPTICAL COAXIAL
OUT OUT
COMPONENT VIDEO OUT
28
COMPONENT VIDEO IN
VIDEO IN
Y P P
B R
B
B A
L R
Y P P VIDEO AUDIO
B R
OUT OUT
TV, projector,
etc.
A
Coaxial feed
Coaxial feed from TV antenna
C
a
Antenna input
(e.g., RF IN)
Satellite, cable, set-top
box, etc.
Antenna input
(e.g., RF IN)
C
Antenna output
(e.g., RF OUT)