Common Functions; Setting The Display Brightness; Adjusting The Bass And Treble; Muting The Av Receiver - Onkyo TX-SR505 Instruction Manual

Common Functions

This section explains functions that can be used with any
input source.
STANDBY/ON
INPUT SELECTOR
1 2
V CR/DVR CBL/SAT
4 5
AUX MULTI CH
7 8
TAPE TUNER
10
DIMMER + 10
0
D TUN
--/---
DIMMER
T V VOL
INPUT
GUIDE
TOP MENU
SP A / B
PLAYLIST/CAT
SETUP
LISTENING MODE
STEREO SURROUND
AUDIO SUBTITLE
CH SEL
TEST TONE CH SEL
PLAY MODE
DISPLAY
VCR
RC-
TONE, –, +
STANDBY/ON
STANDBY
MULTI CH DVD VCR/DVR CBL/SAT
PHONES
A SPEAKERS B TONE STEREO
PHONES

Setting the Display Brightness

You can adjust the brightness of the display.
Press the remote controller's
[DIMMER] button repeatedly to
select: dim, dimmer, or normal
DIMMER
brightness.
Alternatively, you can use the AV
receiver's [DIMMER] button (not
European models).
46
REMOTE MODE
Press
RECEIVER DVD
TAPE/AMP
[RECEIVER]
M D/CDR
C D
3
first
DOCK
T V
6
DVD
9 VCR
C D
CABLE
11 12
CLR SAT SLEEP
ENT
SLEEP
CH
VOL
DISC
ALBUM
PREVIOUS
MENU
MUTING
MUTING
ENTER
PLAYLIST/CAT
RETURN
RANDOM REPEAT
LEVEL - LEVEL +
LEVEL – +
L NIGHT CINE FLTR
DVD HDD
681 M
MASTER VOLUME
TUNING
PRESET
AUX TAPE TUNER C D SETUP ENTER RETURN
AUX INPUT
SETUP MIC VIDEO L AUDIO R
LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE
CLEAR
DIMMER

Adjusting the Bass and Treble

You can adjust the bass and treble for the front speakers,
except when the Direct or Pure Audio (not North Amer-
ican models) listening mode is selected.
1 Press the AV receiver's [TONE]
TONE
button repeatedly to select either
Bass or Treble.
2
Use the TONE [–]/[+] buttons to
adjust.
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Note:
• To bypass the bass and treble tone circuits, select the
Direct or Pure Audio (not North American model) lis-
tening mode.

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.
Press the remote controller's
[MUTING] button.
The output is muted and the MUTING
MUTING
indicator flashes on the display.
To unmute the AV receiver, press the remote control-
ler's [MUTING] button again, or adjust the volume. The
output is unmuted and the MUTING indicator goes off.
Muting is cancelled when the AV receiver is set to
Standby.