Common Functions - Onkyo HT-R510 Instruction Manual

Common Functions

This chapter explains functions that can be used with any
input source.
SPEAKERS A & B
DISPLAY
STANDBY/ON
STANDBY
A SPEAKERS B DISPLAY
PHONES
AUDIO
SELECTOR
PHONES DIMMER
SLEEP
SP A
SP B
CH SEL
TEST
MUTING
Turning Speaker Sets On & Off
You can turn on and off speaker sets A and B individually.
To turn on or off speaker set A, use
A SPEAKERS B
the SPEAKER [A] button, or the
remote controller's [SP A] button.
To turn on or off speaker set B, use
the SPEAKER [B] button, or the
Remote controller
remote controller's [SP B] button.
Press the remote controller's [RCVR/
TAPE] button to select RCVR mode
before using the remote controller.
Indicator A lights up when speaker set A
is on. Indicator B lights up when speaker
set B is on.
A & B speakers indicators
Note:
When you turn on speaker set B, the listening mode for
speaker set A is set to Stereo.
32
DIRECT STEREO
SURROUND DSP
PRESET/ADJUST
SUBWOOFER
DIMMER DIGITAL INPUT MODE MEMORY FM MODE TUNING SPEAKER ADJUST AUDIO ADJUST
CLEAR
DVD VIDEO 1 VIDEO 2 VIDEO 3 TAPE TUNER C D
VCR
DIMMER
CABLE/SAT
CD/DVD
Press [RCVR/
TAPE] to select
RCVR mode.
CH +
LEVEL
VOLUME
Muting the HT-R510
(remote controller only)
With this function you can temporarily mute the output of the
HT-R510.
Remote controller
MASTER VOLUME
VIDEO 3 INPUT
S VIDEO VIDEO L AUDIO R
Muting is cancelled when the HT-R510 is set to Standby.
Displaying Source Information
/
This section explains how to display information about the
currently selected input source.
/
DISPLAY
When the input source is not AM or FM:
Input source
& volume
Sound format*
Input source
& listening
* If the input signal is analog, no sound format information
is displayed. For non-PCM digital sources, the sound format
is displayed. This information is displayed for about three
seconds, then the previously displayed information reap-
pears.
When the input source is AM or FM:
Band, frequency
& preset #
listening mode
Press the remote controller's
[MUTING] button.
The output is muted and the MUTING
indicator flashes on the display, as shown.
To unmute the HT-R510, press the
remote controller's [MUTING]
button again, or adjust the volume.
The output is unmuted and the MUTING
indicator goes off.
Press the [DISPLAY] button.
Press the [DISPLAY] button repeatedly to
cycle through all the information avail-
able for the current input source.
mode
Band &