Networking Problems - Lenovo ThinkStation P500 User Manual

The monitor works when I turn on the computer, but goes blank when I start some
application programs
Solutions:
• Connect the monitor signal cable from your monitor to an appropriate connector on the computer. A
loose cable might cause intermittent problems.
• Install the device drivers for the application programs. Refer to the documentation for the affected
application program to check whether any device drivers are required.
The image appears to be flickering
Solutions:
• The screen might be affected by interference from nearby equipment. Magnetic fields around other
devices, such as transformers, appliances, fluorescent lights, and other monitors might be causing the
problem. Move fluorescent desk lighting or any equipment that produces magnetic fields farther away
from the screen. If this does not correct the problem, turn off the computer. Then, adjust the placement of
the computer and other devices so that they are at least 305 mm (12 inches) apart. Turn on the computer.
• Reset the refresh rate supported by your computer.
1. Right-click a blank area on the desktop.
2. Depending on your Windows version, do one of the following:
– For Windows 7 or Windows 8.1: Click Screen resolution ➙ Advanced settings.
– For Windows 10: Click Display settings. On the Display tab, click Advanced display settings ➙
Display adapter properties.
3. Click the Monitor tab, and then reset the refresh rate to be the highest and noninterlaced.
The image is discolored
Solution: The monitor might be affected by interference from nearby equipment. Move fluorescent desk
lighting or any equipment that produces magnetic fields further away from the monitor. If the problem
persists, do the following:
1. Turn off the monitor.
2. Adjust the placement of the monitor and other devices so that they are at least 305 mm (12 inches) apart.
3. Turn on the monitor.

Networking problems

The following are the most common networking problems. Select your networking problem from the
following list:
• "Ethernet problems" on page 59
• "My computer cannot establish network connections by the built-in wireless networking card" on page 60
• "Sound does not come from the Bluetooth headset or headphone" on page 60
For more information, see "Windows help system" on page 153.
Ethernet problems
My computer cannot connect to the network
Solution: Ensure that:
• The cable is installed properly.
The network cable must be securely connected to both the Ethernet connector of your computer and
the RJ45 connector of the hub. The maximum allowable distance from the computer to hub is 100
.
Chapter 7 Troubleshooting and diagnostics
59