5. Press the retaining clip
the rear to remove it from the computer chassis.
Figure 35. Removing the optical drive bracket
To reinstall the optical drive bracket, do the following:
1. Position the optical drive bay into the chassis at a relative angle of about 45° as shown. Align the two
posts on the top and the bottom of the optical drive bracket with the notches in the computer chassis.
Figure 36. Positioning the optical drive bracket into the chassis
2. Pivot the optical drive bracket inward as shown until it snaps into position.
1
on the top of the optical drive bracket and pivot the bracket outward from
.
Chapter 9
Installing or replacing hardware
89