Adjusting The Bass & Treble; Displaying Source Information - Onkyo 29400021 Instruction Manual

Basic Operations—Continued
TONE, e, r DIMMER
Press
[RECEIVER]
first.
SP LAYOUT
DIMMER
Adjusting the Bass & Treble
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.
1
Press the [TONE] button repeat-
edly to select either "Bass" or
AV receiver
"Treble".
2
Use the Up [r] and Down [e]
buttons to adjust.
AV receiver
Tip:
This procedure can also be performed
on the remote controller by using
[AUDIO] button (see page 104).
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Note:
To bypass the bass and treble tone circuits, select the
Direct, Pure Audio or THX listening mode.
You can display various information about the current
input source as follows.
DISPLAY
DISPLAY
MUTING
Note:
This procedure can also be performed on the AV receiver
by using its [DISPLAY] button.
The following information can typically be displayed for
input sources.
SLEEP
Signal format*
*

Displaying Source Information

Remote Press the [RECEIVER] button,
controller
and then press the [DISPLAY]
button repeatedly to cycle
through the available informa-
tion.
Input source
Listening
mode
Sampling
frequency
Input Signal
Resolution
Output
Resolution
If the input signal is analog, no format information is displayed.
If the input signal is PCM, the sampling frequency is displayed.
If the input signal is digital but not PCM, the signal format and
the number of channels is displayed. For some digital input sig-
nals, including multichannel PCM, the signal format, number of
channels, and sampling frequency is displayed.
Information is displayed for about three seconds, then the previ-
ously displayed information reappears.
61