Connecting An Ri Dock; Connecting A Dock With The Universal Port Connector - Onkyo 29400021 Instruction Manual

Connecting the AV receiver—Continued

Connecting an RI Dock

Not all iPod models output video. For information
about which iPod models are supported by the RI
Dock, see the RI Dock's instruction manual.
■ If Your iPod Supports Video:
Connect your RI Dock's audio output jacks to the
AV receiver's GAME IN or VCR/DVR IN L/R jacks,
and connect its video output jack to the AV receiver's
GAME IN V or VCR/DVR IN V jack. (Onkyo DS-
A2 hookup shown below.)
GAME
IN
IN
GAME
■ If you have an Onkyo DS-A1 RI Dock
Connect its video output jack to the AV receiver's
GAME IN S or VCR/DVR IN S jack.
Notes:
• Enter the appropriate remote control code before using the AV receiver's remote controller for the first time (see
page 125).
• Connect the RI Dock to the AV receiver with an u cable (see page 41).
• Set the RI Dock's RI MODE switch to "HDD" or "HDD/DOCK".
• Set the AV receiver's Input Display to "DOCK" (see page 53).
• See the RI Dock's instruction manual for more information.

Connecting a Dock with the Universal Port Connector

Note:
When UP-A1 series Dock that seated iPod is connected, the power consumption on standby mode slightly increases.
40
VCR/DVR
V V
V
IN
IN
L L
R R
VCR/DVR
Connect one or the
other
■ If Your iPod Doesn't Support Video:
Connect your RI Dock's audio output jacks to the
AV receiver's TV/TAPE IN L/R jacks. (Onkyo DS-
A2 hookup shown below.)
IN
L
R
TV/TAPE