Turning On The Av Receiver; Turning On And Standby - Onkyo 29400021 Instruction Manual

Onkyo av receiver instruction manual
Table of Contents

Advertisement

Turning On the AV receiver

(North American and
Taiwan models)
ON/STANDBY
STANDBY indicator

Turning On and Standby

1
2
AV receiver
or
European, Australian and Asian models
OFF position ( ).
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here's a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Did you connect your TV to an HDMI OUT or COMPONENT VIDEO MONITOR OUT?
If you did, "Monitor Setup" (TX-NR807) on page 43.
■ Run MultEQ Room Correction and Speaker Setup—this is essential!
See "Audyssey MultEQ
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see "HDMI Input Setup" on page 48, "Component Video
Setup" on page 49, or "Digital Audio Input Setup" on page 50
respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see "Changing the Input Display" on page 53.
42
(European, Australian and
Asian models)
(European, Australian and Asian models)
Set the [POWER] switch to the ON position ( ).
The AV receiver enters Standby mode, and the STANDBY indicator comes on.
On the AV receiver, press the [ON/STANDBY] button.
Remote
On the remote controller, press the [RECEIVER] button, followed by the
controller
[ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
Pressing the remote controller's [ON] button again will turn on any components
connected via u.
To turn the AV receiver off, press the [ON/STANDBY] button, or press the remote
controller's [STANDBY] button. The AV receiver will enter Standby mode. To prevent
any loud surprises when you turn on the AV receiver, always turn down the volume
before you turn it off.
: To completely shut down the AV receiver, set the [POWER] switch to the
®
Room Correction and Speaker Setup" on page 54.
ON/STANDBY
STANDBY indicator
POWER
STANDBY
ON
RECEIVER
HDMI
OUT
IN
MD recorder, CD recorder,
TV/TAPE
RI Dock

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ht-rc180Tx-nr807Txnr807b

Table of Contents