Onkyo 29400021 Instruction Manual page 101

Advanced Setup—Continued
Notes:
• If On is selected and the signal can be output by the TV, the AV receiver will output no sound through its
" "
speakers.
• If "On" is selected, "TV Speaker On" appears on the Display by pressing the [DISPLAY] button.
• When TV Control
"
• With some TVs and input signals, no sound may be output even when this setting is set to
try to get audio from your TV, signals from the source component may be converted to the format supported
by your TV.
• When the "Audio TV Out" setting is set to
-compatible TV (see page 26), by controlling the AV receiver's volume, the AV receiver's speakers
will produce sound while the TV's speakers are muted. If your TV is not compatible with
volume level will not change. To stop the AV receiver's speakers producing sound, change the settings,
change your TV's settings, or turn down the AV receiver's volume.
• When the "Audio TV Out" setting is set to "On", the remote controller's [AUDIO] button is disabled.
Lip Sync
The AV receiver can be set to automatically correct any delay between the video and the audio, based on the
data from the connected monitor.
Notes:
• This function works only if your HDMI-compatible TV supports HDMI Lip Sync.
• You can check the amount of delay being applied by the HDMI Lip Sync function on the A/V Sync screen
(see page 93).
x.v.Color
If your HDMI source and HDMI-compatible TV both support the "x.v.Color", you can enable "x.v.Color" on
the AV receiver with this setting.
Notes:
• If the color is unnatural when "x.v.Color" is set to "Enable", change the setting to
• Refer to the connected component's instruction manual for details.
HDMI Control (RIHD)
This function allows
receiver.
Notes:
• , which stands for Remote Interactive over HDMI, is the name of the system control function found
on Onkyo components. The AV receiver can be used with CEC (Consumer Electronics Control), which
allows system control over HDMI and is part of the HDMI standard. CEC provides interoperability between
various components, however, operation with components other than
not be guaranteed.
When set to "On" and close the menu, the name of connected
"RIHD On" are displayed on the AV receiver.
→
"Search..." "(name)"
When the AV receiver cannot receive the name of the component, it is displayed as "Player*" or
"Recorder*", etc ("*" means the number of two or more component).
When set to "Off" and close the menu, "RIHD Off" are displayed on the AV receiver.
→
"Disconnect"
• Set it to Off when a connected piece of equipment is not compatible or it is unclear whether the equipment
" "
is compatible or not.
• Set it to "Off" if the operation is not successful.
• Refer to the connected component's instruction manual for details.
is set to On , this setting is fixed at
" " "
" On
Disable: HDMI Lip Sync disabled (default).
Enable: HDMI Lip Sync enabled.
Disable: "x.v.Color" disabled (default).
Enable: "x.v.Color" enabled.
On: enabled.
Off: disabled (default).
-compatible components connected via HDMI to be controlled with the AV
→
"RIHD On"
"RIHD Off"
Auto .
" "
" or " TV Control" is set to "
-compatible components and
On . When you
" "
On " to hear from speakers of
, the
.
"Disable"
-compatible components can-
101