Speaker Settings - Onkyo 29400021 Instruction Manual

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run
®
Audyssey MultEQ Room Correction and Speaker
Setup again (see page 54).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
If you've connected your front speakers to the FRONT
L/R and SURR BACK/ZONE 2 L/R terminal posts for
bi-amping, you must change the "Speakers Type(Front)"
setting. For hookup information, see "Bi-amping the
Front Speakers" on page 21.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the
volume.
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [q]/[w] but-
tons to select "2. Speaker
Setup", and then press [ENTER].
The "Speaker Setup" menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use the Up and Down [q]/[w] but-
tons to select "1. Speaker Set-
tings", and then press [ENTER].
The "Speaker Settings" menu appears.
2–1. Speaker Settings
Speaker Impedance
Speakers Type(Front)
Powered Zone2
Powered Zone3
4
5
6
Powered Zone 2/3
See "Setting the Powered Zone 2/3" on page 118.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
6ohms
Normal
Not Act
Not Act
Use the Up and Down [q]/[w] but-
tons to select "Speaker Imped-
ance", and then use the Left and
Right [e]/[r] buttons to select:
4ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
Use the Up and Down [q]/[w] but-
tons to select "Speakers
Type(Front)", and then use the
Left and Right [e]/[r] buttons to
select:
Normal: Select this if you've con-
nected your front speakers
normally.
Bi-Amp: Select this if you've con-
nected your front speakers
for bi-amped operation.
Note:
Powered Zone2/3 cannot be used if
"Speakers Type(Front)" is set to
"Bi-Amp".
Press the [SETUP] button.
The setup menu closes.
51