Checking And Adjusting The Auger/Impeller Cable - Toro 38624 Operator's Manual

Figure 37
1. Pin
If the left hand (traction) cable is not properly adjusted,
do the following steps:
1. Loosen the jam nut.
2. Loosen or tighten the turnbuckle to adjust the pin
until it is the proper gap from the front edge of the
slot.
3. Tighten the jam nut (Figure 38).
Figure 38
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Check the
auger/impeller cable and adjust it if
necessary.
Yearly—Check the auger/impeller
cable and adjust or replace it if
necessary.
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover (Figure 39).
2. Turnbuckle
3. With the auger/impeller lever disengaged, ensure
that the gap between the auger clutch assembly and
the tab is 1/16 inch (1.5 mm) (Figure 40).
1. Tab
4. If the auger/impeller cable is not properly adjusted,
do the following steps:
5. Loosen the jam nut (Figure 41).
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (Figure 41).
20
Figure 39
Figure 40
Figure 41
2. Turnbuckle