Installing The Upper Handle; Loose Parts - Toro 38624 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1.
2.
3.
4.
5.
6.
7.
8.

1. Installing the Upper Handle

4 Handle bolts
4 Curved washers
4 Locknuts
Procedure
Note: Do not remove the rubber band until you have
installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important: Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables and the wire for the
headlight are not pinched between the handle
sections.
Description
Handle bolts
Curved washers
Locknuts
No parts required
Carriage bolts
Locknuts
Cable ties
No parts required
No parts required
No parts required
No parts required
Qty.
4
4 Install the upper handle.
4
–
Install the traction control linkage.
2
Install the chute control rod.
2
2 Connect the wire to the headlight.
–
Fill the engine with oil.
–
Check the tire pressure.
–
Check the skids and scraper.
–
Check the operation of the traction drive.
1. Cables
2. Secure the upper handle with 4 handle bolts,
4 curved washers, and 4 locknuts from the loose
parts bag (Figure 4).
7
Use
Figure 3