Installing The Traction Control Linkage - Toro 38624 Operator's Manual

2. Installing the Traction
Control Linkage
Procedure
1. Remove the hairpin cotter and washer from the
lower end of the speed control rod and insert the
lower end of the rod into the lower link arm so that
the bent end of the speed control rod faces rearward
(Figure 5).
2. Secure the lower end of the speed control rod with
the washer and hairpin cotter that you previously
removed.
3. Remove the hairpin cotter and the outer washer
from the trunnion on the upper end of the speed
control rod (Figure 6).
Figure 4
Figure 5
1. Speed selector lever
2. Trunnion
Note: To make installation easier, leave the inner
washer on the trunnion (Figure 6).
4. Shift the speed selector lever into Position R2.
5. Rotate the lower link arm fully upward
(counterclockwise) (Figure 7).
6. Lift up on the speed control rod and insert the
trunnion into the hole in the speed selector lever
(Figure 6).
Note: If the trunnion does not fit into the hole
when you lift up on the speed control rod, rotate the
trunnion upward or downward on the speed control
rod until it fits.
7. Secure the trunnion and upper end of the speed
control rod with the outer washer and hairpin cotter
that you previously removed.
8
Figure 6
3. Inner washer
4. Outer washer
Figure 7